Panasonic WJ-MP204C - Manual (Page 20)

20
● Setup menus
There are two setup menu groups depending on the communication protocol used in the system, menus for PS • Data and for
the Camera Communication Protocol. MODE DIP switch # 3 on the rear of the unit is set to the position of the used protocol,
and it specifies what menu group is displayed on the monitor. Menu trees are shown below for two protocols.
COMMUNICATION
UNIT ADDRESS
BAUD RATE
DATA BIT
PARITY CHECK
STOP BIT
WAIT TIME
SYSTEM
ALARM MODE
MONITOR SPOT
MONITOR SPOT
ALARM DISPLAY
SITE ALARM
TERM. ALARM
ALARM OUTPUT
ALARM DATA
COMP/VD2/DATA
CAMERA IN
COMP
VD2
DATA
VS/VD INPUT
CAMERA CONFIG
CAMERA CONFIG
DAISY MODE
TERMINAL
● Setup menus for PS • Data
COMMUNICATION
CAM ADDRESS
CAM ADDRESS
BAUD RATE
DATA BIT
PARITY CHECK
STOP BIT
WAIT TIME
DELAY TIME
XON/XOFF
SYSTEM
ALARM MODE
MONITOR SPOT
ALARM DISPLAY
SITE ALARM
TERM. ALARM
ALARM OUTPUT
ALARM DATA
COMP/VD2/DATA
CAMERA IN
COMP
VD2
DATA
VS/VD INPUT
DAISY MODE
TERMINAL
● Setup menus for Camera Communication
Protocol