beautypg.com

Philips AVCHD HDC-TM20 User Manual

Page 67

background image

67

VQT2B30

Wind noise reduction:
≥ When the Intelligent auto mode is set to on,

[WIND CUT] is set to [ON], and the setting
cannot be changed.

≥ The sound quality may be changed if this

function is activated in strong winds.

Microphone setup:
≥ If you wish to record higher quality sound and

maintain realism even when zooming in, for
instance recording a music recital, we
recommend setting [MIC SETUP] to
[SURROUND].

Microphone level:
≥ When the Intelligent auto mode is on, the

setting is fixed to [AUTO] and cannot be
changed.

≥ When [MIC SETUP] is [ZOOM MIC], the

volume will be different depending on the zoom
rate.

≥ The microphone input level meter shows the

largest volume for the microphones.

≥ You cannot record with the audio completely

muted.

Hi-speed burst shooting:
≥ If you turn off the power or change the mode to

, this function is cancelled.

≥ The maximum number of times you can record

on a media: 15.
(In the case of SD cards it is the maximum
number of recordable scenes per card.)

≥ Colour balance and brightness on the screen

may change with some light sources such as
fluorescent lamps.

≥ Image quality is different from ordinary still

picture recording.

Self-timer:
≥ The self-timer standby mode is cancelled when

you press the recording start/stop button to
start motion picture recording.

≥ Setting the self-timer to [2 SECONDS] is a

good way to prevent image shake when the

button is pressed while using a tripod etc.

Built-in flash:
≥ Set the flash to [OFF] where using a flash is

prohibited.

≥ If the

ß indication etc. flashes when the

button is pressed halfway, the flash is not
activated.

≥ The available range of the flash is approx. 1 m

to 2.5 m in dark places.

≥ Using the flash fixes a shutter speed to 1/500

or slower.

Red eye reduction:
≥ The flash is activated 2 times.
≥ Red eye phenomenon may appear depending

on the recording conditions.

≥ When faces are detected in the Intelligent auto

mode, the red eye reduction is set to on.

≥ Do not use the flash with the ND filter (optional)

attached.

≥ A conversion lens (optional) can block the flash

and may cause a vignetting effect.