Status display (status display), Status display position (status position), Hdd full (hdd full) – Panasonic WJ-HD200 User Manual
Page 60: Remote led (remote led), Hdd check (hdd check), On/off (on/off), Title (title), Title position (position), System setup system setup, Camera title camera title

61
8
On/Off (ON/OFF)
ON:
Displays the camera title.
OFF:
Hides the camera title.
8
Title (TITLE)
Usable characters:
Are shown in the window.
Digit length:
5 digits maximum.
8
Title Position (POSITION)
Right-Lower:
Displays the title in the right lower corner.
Right-Upper:
Displays the title in the right upper cor-
ner.
Left-Lower:
Displays the title in the left lower corner.
Left- Upper:
Displays the title in the left upper corner.
Click the [SET] button if all are adequately set.
■
System Setup SYSTEM SETUP
8
Password Lock (PASSWORD LOCK)
Buttons on the front panel of the WJ-HD200 will be
password-protected or freed.
ON:
Enables password-protection.
OFF:
Disables password-protection.
8
Password All (PASSWORD ALL)
Enter a five-digit password comprising 1 through 8 to
protect normal operations and setup operations from
unauthorized access.
Available numerals:
From 11111 to 88888
8
Status Display (STATUS DISPLAY)
ON:
Status display is enabled.
OFF:
Status display is disabled.
8
Status Display Position (STATUS POSITION)
Right-Lower:
Displays status in the right lower corner.
Right-Upper:
Displays status in the right upper corner.
Left-Lower:
Displays status in the left lower corner.
Left-Upper:
Displays status in the left upper corner.
8
HDD Full (HDD FULL)
1 % - 99 %:
The FULL indicator blinks when the remain-
ing capacity reaches the selected value. This will take
effect when DISK END MODE is set to STOP in the
RECORD SETUP.
8
Remote LED (REMOTE LED)
ON:
REMOTE LED turns on when the network controls
the recorder.
OFF:
REMOTE LED is deactivated.
8
HDD Check (HDD CHECK)
ON 0:00 - 23:00:
The recorder checks the HDD at the
specified time every day.
OFF:
Check is deactivated.
Click the [SET] button if all are adequately set.
Click the [CAMERA TITLE SETUP] button to open CAMERA
TITLE window.
■
Camera Title CAMERA TITLE