Lexmark 1200 - Manual (Page 44)

30 Chapter 2: Changing printer settings
Download Target RAM*
Flash
Disk
The Download Target menu item specifies where you want to store downloaded resources.
Storing downloaded resources in flash memory or an optional hard disk is permanent storage
rather than the temporary storage that RAM provides. You can add resources to flash memory
or disk until the device is full. Use your software application or the MarkVision printer utility to
download resources to the printer.
The Download Target menu item is only displayed if the flash memory or hard disk is not
defective or Read/Write or Write protected. Disk is not an available value for Download Target
if Job Buffer Size is set to 100%.
Print Timeout Disabled
1…255 (90*)
The Print Timeout setting determines the time (from 1 to 255 seconds) the printer waits before
printing the last page of a print job that does not end with a command to print the page. The
print timeout counter does not start until the printer displays the Waiting message.
When a print timeout occurs, the printer stores the page in the print buffer.
When Print Timeout is disabled, the printer does not print the last page of a print job until one
of the following occurs:
• The printer receives enough information to fill the page.
• The printer receives a Form Feed command.
• You select Print Buffer from the Job Menu. See page 28 for more information.
Wait Timeout Disabled
15…65535 (40*)
The Wait Timeout setting determines the amount of time in seconds the printer waits to
receive additional bytes of PostScript data from the computer. When this timeout expires, the
print job is canceled. Select Disabled to turn Wait Timeout off.
The Wait Timeout menu item is only available when using PostScript Level 2 emulation. The
setting has no effect on PCL emulation print jobs.
Setup Menu (continued)
Menu item Values
*Factory default