Lanier 5625 User Manual

Page 54

Copying

❒ Select one of the following settings or keys:

•

[Normal]

: normal paper

•

[Thick]

: thick paper, post cards, adhesive labels, translucent paper

•

[OHP]

: OHP transparencies

•

[Duplex]

: Use for copying onto the reverse side of paper that has been al-

ready copied onto.

⇒

P.48 “Copying onto the reverse side of paper”.

•

[Duplex Thick]

: Use for copying onto the reverse side of thick paper (105-

160g/m

, 28-43 lb) that has been copied onto.

⇒

P.48 “Copying onto the re-

verse side of paper”.

•

[Custom]

: Use to specify a non-standard sized.

⇒

P.44 “Copying onto non-

standard size paper with the bypass tray”.

❒ If the copy paper is bent, correct it before setting paper in the bypass tray. If

the bend is not corrected, a paper misfeed might occur.

❒ When you copy onto OHP transparencies, you can select whether a blank slip

sheet is inserted between OHP transparencies.

❒ When you set several sheets at a time, fan them to get air between them before

❒ If the copy paper is curled, gently roll it to remove the curl.
❒ When you copy onto OHP transparencies, insert them with the copy side up.
❒ Do not stack copy paper above the limit mark.
❒ When setting non-standard size paper, be sure to set the size after pressing

the

[Custom]

key.

Copying onto standard size paper with the bypass tray

Note

❒ When you copy onto the reverse side of paper that has been already copied

onto,

⇒

P.48 “Copying onto the reverse side of paper”.

Number of sheets that can
be set at one time

Normal paper: 50 sheets

Thick paper, OHP transparencies: 30 sheets (smaller
than 8"

13"), 15 sheets (8"

13" or larger)

Adhesive labels: 30 sheets

Translucent paper: 50 sheets

Post cards: 25 sheets