Linksys SPA9000 - Manual (Page 24)

17 Chapter 5: Using the Interactive Voice Response Menu
Using the Interactive Voice Response Menu
IP Telephony System
Set Primary DNS
Server IP Address 161 Enter the IP address
using numbers on the
telephone keypad. Use
the * (star) key when
entering a decimal point. First, set the Internet Connection Type
to static IP address; otherwise, you
will hear, “Invalid Option,” if you try to
set the IP address of the primary DNS
server.
Set the Mode 201 Press 0 to select the
router/NAT mode.
Press 1 to select the
bridge/switch mode. Use the router/NAT mode when the
Internet phones are on the Local Area
Network (LAN) side.
Use the bridge/switch mode when the
Internet phones are on the Wide Area
Network (WAN) side.
Configure
Auto-Attendant
Messages 72255 Refer to the “Configuring the
Auto-Attendant Messages” section at
the end of this chapter.
Enable/Disable WAN
Access to the
Web-based Utility 7932 Press 1 to enable.
Press 0 to disable. Use this setting to enable or disable
WAN access to the Web-based Utility.
(This Utility lets you configure the
System.)
Manual Reboot 732668 After you hear, “Option successful,”
hang up the phone. The System will
automatically reboot.
Factory Reset 73738 Press 1 to confirm.
Press * (star) to cancel. If necessary, enter the password. The
System will request confirmation;
enter 1 to confirm. You will hear,
“Option successful.” Hang up the
phone. The System will reboot, and all
settings will be reset to their factory
default settings.
Interactive Voice Response Menu
Action Command
(press these
keys on the
telephone) Choices Description
NOTE: This feature may be protected by a
password available only from your ITSP.
If you need to enter a password, refer to the
following section, “Entering a Password.”