Lincoln Electric BULLDOG SVM208-A - Manual (Page 90)

GENERATOR
ENGINE
FIGURE F.14 – GENERATOR AND ENGINE LOCATION
STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
PROCEDURE
1. Remove control panel cove by removing the 20
screws with a 3/8” nutdriver.
2. Remove the right case side by removing the 5
screws using a 3/8” nutdriver.
3. Make sure the run/off switch on the rear of the
engine is in the off position. Remove the gas
line from the engine by closing the gas valve
and pinching open the clip using a pair of
needlenose pliers.
4. Label and remove all of the leads that are com-
ing up from the center hole in the control box
from the stator. See Wiring Diagram.
5. The engine can be removed by unbolting the
two 9/16” anchor bolts from the engine side and
the two 1/2” bolts from the generator side. Pull
the engine/generator from the right side of the
welder.
TROUBLESHOOTING AND REPAIR F-42 F-42
BULLDOG® 140
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC