Lincoln Electric BULLDOG SVM208-A - Manual (Page 89)

Service and repair should be performed only by Lincoln Electric factory trained personnel.
Unauthorized repairs performed on this equipment may result in danger to the technician
or machine operator and will invalidate your factory warranty. For your safety and to avoid
electrical shock, please observe all safety notes and precautions detailed throughout this
manual.
If for any reason you do not understand the test procedures or are unable to perform the
test/repairs safely, contact the Lincoln Electric Service Department for electrical trou-
bleshooting assistance before you proceed. Call 1-888-935-3877.
TEST DESCRIPTION
The following procedure will aid the technician in removing the Stator and/or Rotor for
maintenance or replacement of either component.
MATERIALS NEEDED
Lincoln Electric Rotor Removal Kit (S20925) - FOR ROTOR REMOVAL ONLY
5/16” Nutdriver
1/2” Socket Wrench
6” Socket Extension
Slot Head Screw Driver
5/8” Socket Wrench
7/16” Socket Wrench
7/16” Open or Box End Wrench
3/4” Socket or Box End Wrench
1/2” Socket or Box End Wrench
Needlenose Pliers
Diagonal Cutters
Torque Wrench (ft lbs)
Babbitt, Leather, or Wooden Mallet
Volt/Ohmmeter
12” (long) Feeler Gauge (.010)
INSTRUCTIONS
For stator removal only, follow steps 1 -8 under STATOR REMOVAL PROCEDURE.
For rotor removal, follow the STATOR REMOVAL PROCEDURE, ROTOR REMOVAL
PROCEDURE.
STATOR/ROTOR REMOVAL AND REPLACEMENT
TROUBLESHOOTING AND REPAIR F-41 F-41
BULLDOG® 140
WARNING
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC