Lenovo THINKCENTRE 4485 - Manual (Page 66)

Diagnostic Error Code FRU/Action
015-196-XXX USB port test halt, error threshold exceeded 1. Press F3 to review the log file
2. Re-start the test to reset the log file
015-197-XXX USB port test warning 1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using the
Setup Utility program” on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
015-198-XXX USB port test aborted 1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using the
Setup Utility program” on page 43
2. Flash the system and re-test. See “Updating
(flashing) the BIOS from a disc” on page 475
3. Go to “Undetermined problems” on page 71
015-199-XXX USB port test failed, cause unknown 1. Go to “Undetermined problems” on page 71
2. Flash the system and re-test. See “Updating
(flashing) the BIOS from a disc” on page 475
3. Replace component under function test
018-000-XXX PCI Card Test Passed No action
018-0XX-XXX PCI Card Failure 1. Riser card, if installed
2. System board
018-195-XXX PCI Card Test aborted by user 1. PCI card
2. Information only Re-start the test, if necessary
018-196-XXX PCI Card test halt, error threshold exceeded 1. Press F3 to review the log file
2. Re-start the test to reset the log file
018-197-XXX PCI Card test warning 1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using the
Setup Utility program” on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
018-198-XXX PCI Card test aborted 1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using the
Setup Utility program” on page 43
2. Flash the system and re-test. See “Updating
(flashing) the BIOS from a disc” on page 475
3. Go to “Undetermined problems” on page 71
018-199-XXX PCI Card test failed, cause unknown 1. Go to “Undetermined problems” on page 71
2. Flash the system and re-test. See “Updating
(flashing) the BIOS from a disc” on page 475
3. Replace component under function test
58 ThinkCentre Hardware Maintenance Manual