Lowrance electronic Lowrance GlobalMap 5200C - Manual (Page 143)

137
EP-15 Fluid Level Calibration
The default calibration for the EP-15 Fluid Level is just as accurate as
standard fluid level gauges. If, however, the tank has an irregular
shape or greater accuracy is needed, calibration is recommended. There
are three calibration options: 2-Point, 3-Point and 5-Point.
2-Point Calibration
A 2-point calibration is best suited for rectangular or square-shaped
tanks, where the capacity of the top half of the tank matches the capac-
ity in the lower half of the tank. In a two-point calibration, you will set
two points, one each for empty and full levels.
You can begin calibration at either of the two points, but we recom-
mend starting with an empty tank. You will fill the tank to complete
calibration.
1. Press
MENU| MENU
, use ↓ ↑ to select
NMEA 2000
and press
ENT
.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the EP-15 Fluid Level and press
ENT
.
4. Press ↓ to select
C
ALIBRATE
and press
ENT
. The Device Calibration
menu will appear. Instructions on Calibration will be listed at the top
of the menu.
5. Highlight
N
UM
P
TS
, press
ENT
and select 2. Press
ENT
.
6. Select
F
LUID
L
EVEL
,
press
ENT,
then select
E
MPTY
L
EVEL
and press
ENT.
7. Make sure the fuel tank is empty, highlight
C
ALIBRATE
and press
ENT
.
The following message will appear: Empty Level Calibration Com-
pleted.
Press ENT.
8.
Fill up your tank, highlight
F
LUID
L
EVEL
and press
ENT.
9.
Select
F
ULL
L
EVEL
and press
ENT.
Highlight
C
ALIBRATE
and press
ENT.
10.
The following message will appear
:
Full level Calibration Com-
pleted. Press
ENT
, then press
EXIT
repeatedly to get back to the main
display.