beautypg.com

Lowrance electronic Lowrance GlobalMap 5200C User Manual

Page 138

background image

132

2. Highlight

B

US

S

ETUP

and press

ENT

, which will open the Bus Configu-

ration menu. A list of network devices will be at the top of the page.
3. Select the desired fluid level and press

ENT

. The Fluid Level Device

Configuration menu will appear.
4. Highlight

T

ANK

S

IZE

and press

ENT

. Use

↑ ↓ ,← → to input the size of

the tank and press Enter. The following message will appear: Are you
sure you wish to change this device's configuration?
5. Select

Y

ES

and press

ENT

. Press

EXIT

repeatedly to get back to the

main display.
Advanced Options menu
The Fuel Flow sensor Advanced Options menu contains two categories:

Instance and Restore Defaults.

Instance

The Instance command is intended for use only by experienced NMEA

2000 network technicians. Instance allows network technicians to re-

solve certain electronic probe conflicts. This is most likely to occur if the

network includes LMF-200 or LMF-400 digital gauges, which support

the display of fewer electronic probes than your GPS or sonar/GPS unit.
If you want to use your unit in a network including one of these digital

gauges, you may need to consult customer service. You should never

need this command if you are connecting your unit to a network with

similar display units and/or a series of electronic probes.

Restore Defaults

The Restore Defaults command allows you to reset an individual EP-15

Fluid Level Sensor's settings to factory defaults. If, for example, you

execute the Restore Defaults command from your Gray Water Fluid

Level Advanced Options menu, only the settings for the Gray Water

Fluid Level will be reset to factory defaults. Other fluid levels on the

network will not be affected.

To restore default settings:

1. Press

MENU| MENU

, use

↑ ↓ to select

NMEA

2000

and press

ENT

. The

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-

agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-

chronization.
2. Highlight

B

US

S

ETUP

and press

ENT

, which will open the Bus Configu-

ration menu. A list of network devices will be at the top of the page.
3. Select the desired fluid level and press

ENT

. The Device Configura-

tion menu will appear.
4. Highlight

A

DVANCED

O

PTIONS

and press

ENT

.