Lowrance electronic Lowrance GlobalMap 5200C User Manual

Page 134

128

5. Highlight the desired Temp Type and press

ENT

. The following con-

firmation message will appear: Are you sure you wish to change this
device's configuration?
6. Highlight

and press

ENT

. Press

EXIT

repeatedly to get back to the

main display.
Advanced Options menu
The Temp sensor Advanced Options menu contains two categories: In-

stance and Restore Defaults.

Instance

The Instance command is intended for use only by experienced NMEA

2000 network technicians. Instance allows network technicians to re-

solve certain electronic probe conflicts. This is most likely to occur if the

network includes LMF-200 or LMF-400 digital gauges, which support

the display of fewer electronic probes than your GPS or sonar/GPS unit.
If you want to use your unit in a network including one of these digital

gauges, you may need to consult customer service. You should never

need this command if you are connecting your unit to a network with

similar display units and/or a series of electronic probes.

Restore Defaults

The Restore Defaults command allows you to reset an individual EP-35

Temp Sensor's settings to factory defaults. If, for example, you execute

the Restore Defaults command from your Water Temp's Advanced Op-

tions menu, only the settings for the Water Temp will be reset to fac-

tory defaults. Other temps on the network will not be affected.

To restore default settings

1. Press

MENU| MENU

, use

↑ ↓ to select

NMEA

2000

and press

ENT

. The

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-

agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-

chronization.
2. Highlight

ETUP

and press

ENT

, which will open the Bus Configu-

ration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press

ENT

. The Device Configura-

tion menu will appear.
4. Highlight

DVANCED

PTIONS

and press

ENT

5. Select

ESTORE

EFAULTS

and press

ENT

. The following message will

appear: Are you sure you wish to change this device's configuration?
6. Highlight

and press

ENT

. Press

EXIT

repeatedly to get back to the

main display.