Lanier LD075 - Manual (Page 84)

Copying
76
2
CCCC
Press the key to select the chapter
number.
DDDD
Press the [Insert Sheet] key.
EEEE
Select the paper tray for slip
sheets.
FFFF
Select [Before] to insert slip sheets
before the page you specify. Se-
lect [After] to insert slip sheets af-
ter the page you specify. Enter the
page number with the number
keys.
GGGG
Press the [Insert Quantity] key, and
enter the number of sheets you
wish to insert with the number
keys.
HHHH
Press the [Next Chapter] key.
IIII
To specify another location where
to insert sheets, repeat steps
DDDD to
HHHH.
JJJJ
When you have finished specify-
ing all settings, press the [OK] key.
KKKK
Press the [OK] key.
LLLL
Select the paper tray that contains
paper for copying originals.
MMMM
Place originals, and then press the
{{{{Start}}}} key.
Slip Sheets
Every time an original page changes,
a slip sheet is inserted. This function
can be used to insert a slip sheet auto-
matically between each OHP trans-
parency copied or used as a stack
function. You can also copy onto the
inserted slip sheets.
Preparation
Before selecting this function,
specify the paper tray for slip
sheets.
⇒ "Slip Sheet Tray" in the
General Settings Guide
If “1 Sided
→ 2 Sided”is selected,
change it to “1 Sided
→ 1 Sided”.
Note
❒ Load slip sheets of the same size
and in the same orientation as the
copy paper or OHP transparency.
❖ ❖ ❖ ❖ When using OHP transparencies set
on the bypass tray
• Copy
1
2
3
1
2
3
2
2 2
1
2
1 1 1
MartiniC1_GBcopy4_FM.book Page 76 Tuesday, April 23, 2002 6:23 PM