Table 10-1. monitor mode commands – Lantronix UDS2100 User Manual
Page 65

10: Monitor Mode
UDS2100 User Guide
65
Table 10-1. Monitor Mode Commands
Command
Command Name
Function
VS x.x.x.x
Version
Queries software header record (16 bytes) of
unit with IP address x.x.x.x.
GC x.x.x.x
Get Configuration
Gets configuration of unit with IP address
x.x.x.x as hex records (120 bytes).
SC x.x.x.x
Send Configuration
Sets configuration of unit with IP address
x.x.x.x from hex records.
PI x.x.x.x
Ping
Pings unit with IP address x.x.x.x to check
device status.
AT
ARP Table
Shows the unit’s ARP table entries.
TT TCP
Connection
Table
Shows all incoming and outgoing TCP
connections.
NC Network
Connection
Shows the unit’s IP configuration.
RS
Reset
Resets the unit’s power.
QU
Quit
Exits diagnostics mode.
G0, G1, ....,Ge, Gf
Get configuration
from memory page
Gets a memory page of configuration
information from the device.
S0, S1,...,Se, Sf
Set configuration to
memory page
Sets a memory page of configuration
information on the device.
GM
Get MAC address
Shows the unit's 6-byte MAC address.
SS
Set Security record
Sets the Security record without the encryption
key and length parameters. The entire record
must still be written, but the encryption-specific
bytes do not need to be provided (they can be
null since they are not overwritten).
Note:
Entering any of the commands listed above generates one of the
following command response codes:
Table 7-2. Command Response Codes
Response
Meaning
0>
OK; no error
1>
No answer from remote device
2>
Cannot reach remote device or no
answer
8> Wrong
parameter(s)
9> Invalid
command