Lantronix UDS2100 - Manual (Page 34)

4: Configuration Using Web Manager
UDS2100 User Guide 34
Accept Incoming Select Yes to accept incoming UDP datagrams. The
default setting is Yes.
Endpoint Configuration
Local Port Enter the local port number.
Remote Port Enter the port number of the remote device.
Remote Host Enter the IP address of the remote device.
Device Address Table The table is enabled when Datagram Type is set to FD.
Enter values between 1 and 255 to identify units on the
local network of device servers.
Note: Lantronix Tech Support supports Datagram type 01.
Datagram Type FD is for OEM use.
3. When you are finished, click the OK button.
4. On the main menu, click Apply Settings.
Apply Settings
1. To save and apply the configuration changes to the device server, click the
Apply Settings button.
Note: Clicking OK on each page does not change the configuration on the device.
OK tells the UDS2100 what changes to use; Apply Settings makes the changes
permanent and reboots the UDS2100.
Apply Factory Defaults
1. Click the Apply Defaults button to set the device server back to the default
settings. For details see Default Settings on page 59.
2. Click Yes to set factory settings, or click No to cancel.