Lantronix UDS2100 - Manual (Page 20)

3: Getting Started
UDS2100 User Guide 20
3. Continue with step 4 in 5: Configuration via Telnet or Serial Port (Setup Mode) .
Assigning the IP Address: Serial Port Login
To assign the IP address and other network settings using a serial connection :
1. Connect a console terminal or a PC running a terminal emulation program to the
unit's serial port. The default serial port settings are 9600 baud, 8 bits, no
parity, 1 stop bit, no flow control
.
2. To enter Setup Mode, cycle the unit's power (power off and back on). After
power-up, the self-test begins and the red Diagnostic LED starts blinking. You
have
one second to enter three lowercase x characters.
Note: The easiest way to enter Setup Mode is to hold down the x key at
the terminal (or emulation) while powering up the unit.
3. Select 0 (Server Configuration) and follow the prompts until you get to
IP address .
4. Enter the new IP address, subnet mask, and gateway (if applicable).
5. Do one of the following:
Continue with 5: Configuration via Telnet or Serial Port (Setup Mode) .
Select 9 to save and exit Setup Mode. The unit performs a power reset.