beautypg.com

Installing the uds – Lantronix UDS2100 User Manual

Page 14

background image

3: Getting Started

UDS2100 User Guide

14

Installing the UDS

Figure 3-1. UDS2100 Connected to Serial Device and Network

To install the unit:

To install the unit, complete the following steps in order. Refer to the numbers in the
previous figure.

1. Connect a serial device to your unit. See

2: Introduction

for more information

about what kinds of device attachments the unit supports.

2. Connect an Ethernet cable to the 10/100 port.

3. Supply power to your unit using the power supply that was included in the

packaging.

Note:

The required input voltage is 9-30 VDC (center +)

(1.8W maximum power).

4. Supply power to the serial device.

Note:

If you encounter a problem, please see

11: Troubleshooting and

Contact Information

.