Lantronix UDS2100 - Manual (Page 32)

4: Configuration Using Web Manager
UDS2100 User Guide 32
by default.
Remote Port Enter the remote port number.
Remote Host Enter the IP address of the remote device.
Common Options
Telnet Mode This field is available for configuration only when Active
Connect is set to None. Select Enable to permit Telnet
communication to the UDS2100 unit.
Terminal Name This field is available for configuration only when Telnet
Mode is set to Enable.
Use the terminal name for the Telnet terminal type. Enter
only one name. When this option is enabled, the unit also
reacts to the end of record (EOR) and binary options,
which can be used for applications such as terminal
emulation to IBM hosts.
Connect Response A single character is transmitted to the serial port when
there is a change in connection state. The default setting
is None.
Use Hostlist If this option is set to True, the device server scrolls
through the host list until it connects to a device listed in
the host list table. Once it connects, the unit stops trying
to connect to any others. If this connection fails, the unit
continues to scroll through the table until it connects to
another IP in the host list.
The host list is disabled for Manual Mode and for Modem
Mode. The unit will not accept a data connection from a
remote device when the host list option is enabled.
LED Select Blink for the status LEDs to blink upon connection
or None for no LED output. The default setting is Blink.
Disconnect Mode
On Mdm_Ctrl_In Drop Set to Yes for the network connection to or from the serial
port to drop when modem_control_in (DSR) transitions
from a high state to a low state. The default setting is No.
Hard Disconnect When set to Yes, the TCP connection closes even if the
remote site does not acknowledge the disconnect
request.
With EOT Select Yes to drop the connection when Ctrl-D or Hex 04
is detected. Both Telnet Mode and Disconnect with EOT
must be enabled for Disconnect with EOT to function
properly. Ctrl+D is only detected going from the serial
port to the network. The default setting is No.
Inactivity Timeout Use this parameter to set an inactivity timeout. The unit
drops the connection if there is no activity on the serial
line before the set time expires. Enter time in the format
mm:ss, where m is the number of minutes and s is the
number of seconds. To disable the inactivity timeout,
enter 00:00.