Configuration using web manager, Accessing uds2100 using deviceinstaller – Lantronix UDS2100 User Manual
Page 21
UDS2100 User Guide
21
4
4
:
:
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
U
U
s
s
i
i
n
n
g
g
W
W
e
e
b
b
M
M
a
a
n
n
a
a
g
g
e
e
r
r
You must configure the unit so it can communicate on a network with your serial
device. For example, you must set the way the unit will respond to serial and network
traffic, how it will handle serial packets, and when to start or close a connection.
The unit’s configuration is stored in nonvolatile memory and is retained without
power. You can change the configuration at any time. The unit performs a reset after
you change and store the configuration.
In this chapter, we describe how to configure the UDS2100 using Web Manager,
Lantronix’s browser-based configuration tool. (For information on using Setup Mode,
our command line configuration interface, see
5: Configuration via Telnet or Serial
Note:
The examples in this section show a typical device. Your device may have
different configuration options.
Accessing UDS2100 Using DeviceInstaller
Note:
Make note of the hardware (MAC) address. You will need it to locate
the UDS2100 using DeviceInstaller. For more information on the hardware
address, see
on page 15
Follow the instructions on the product CD to install and run DeviceInstaller.
1. Click
Start
Programs
Lantronix
DeviceInstaller
DeviceInstaller.
If the
PC has more than one network adapter, a message displays requesting the
selection of a network adapter. Select an adapter and click OK.
2. Click
the
Search
icon
. The list of Lantronix device servers displays in the
left pane.
3. Click the UDS folder. The list of available UDS products displays.
4. Expand the list of UDS2100s by clicking the + symbol next to the UDS2100 icon.
5. Select the UDS2100 unit by clicking its hardware address.
6. In the right pane, click the Web Configuration tab.
7. To view the UDS2100’s Web Manager in the current DeviceInstaller window,
click the Go button. To open the Web Manager in a web browser, click the
External
Browser button. The Web Manager displays.
Note:
Alternatively, to open Web Manager, open your web browser and enter
the IP address of the
UDS2100.