Kodak 800 SERIES - Manual (Page 78)

Maintenance 3-26
NovaJet 800 Series Service Manual
MEASURE
SECOND MEASURE
FIRST
MEASURE
LAST
ADJUST IF
NECESSARY
Figure 3-12. Measurement Positions for Slide Shaft.
3. Measure the right side (next to media alignment mark) and note
the difference. Divide this amount by two.
4. Measure just off the center of the slide shaft and adjust the center
turnbuckle with an open ended wrench if required, for the average
value (the value found in step 3.) See Figure 3-13.
NOTE
The NovaJet 850 60 inch model has two
turnbuckles, so both of these need to be
adjusted together for the center position.