Stepper motor winding resistance check – Kodak 800 SERIES User Manual
Page 67
Maintenance
3-15
NovaJet 800 Series Service Manual
MAINTENANCE
Stepper Motor Winding Resistance Check
*
B
A
Figure 3-8. Stepper Motor.
1.
Disconnect the stepper motor connection from J7 on the Main
PWA.
2.
Using a standard ohmmeter or multimeter, measure between
pins 1 (red wire) and 3. Point A in Figure 3-8. The asterisk in
Figure 3-8 identifies the red wire.
3.
The reading should indicate 7.2-8.0 ohms.
4.
Continue by measuring between pins 4 and 6. Point B in
Figure 3-8.
5.
Reading should also indicate 7.2-8.0 ohms.
6.
If either measurement is out of tolerance, replace the stepper
motor.
See also other documents in the category Kodak Camcorders:
- 5302TM (4 pages)
- M590 (29 pages)
- M590 (67 pages)
- Zx1 (25 pages)
- EASTMAN 7272TM (4 pages)
- KLIC-7004 (27 pages)
- KLIC-7004 (28 pages)
- D-32 (16 pages)
- ZM1 (26 pages)
- C-41RA (8 pages)
- EKTACHROME 7280 (6 pages)
- I (12 pages)
- E-6 (2 pages)
- Zi8 (34 pages)
- 2393 (6 pages)
- CGPM (7 pages)
- DS1000 (2 pages)
- PLAYSPORT Zx3 (23 pages)
- PLAYFULL ZE1 (34 pages)
- DC 4800 (1 page)
- ZE2 (36 pages)
- DC 265 (2 pages)
- DVC325 (2 pages)
- DVC325 (38 pages)
- 7219 (6 pages)
- ZxD (26 pages)
- C610 (22 pages)
- C610 (55 pages)
- ISBN 0-87985-749-8 (82 pages)
- F620 Zoom (110 pages)
- I5000 (2 pages)
- ZM2 (25 pages)
- H-1-5205T (6 pages)
- Camcorder (2 pages)
- PLAYTOUCH ZI10 (39 pages)
- AEROCHROME III AS-2569 (6 pages)
- mc³ (88 pages)
- Sharp Focus (2 pages)
- KD60 (2 pages)
- KE25 (2 pages)
- KB Zoom (2 pages)
- i60 Reusable 35mm Film Camera (Very Peri) (5 pages)