Kodak 800 SERIES - Manual (Page 170)

Troubleshooting 4-71
NovaJet 800 Series Service Manual
Figure 4-73. Carriage Head Assembly.
Carriage Test
Perform a Servo Cycle Test (10 cycles is sufficient) to verify carriage
bushings are defective. Ensure Halt time does not exceed 90. Left to
Right resistances are normally higher than Right to Left due to carriage
heads pushing against ink delivery chain. Acceleration is also higher than
Slew or Deceleration values.
Figure 4-74. Servo Cycle/PWM Menu.
If Halt Time is above 60 excessive drag exists on the carriage assemblies
and the servo motor may be defective or the carriage bushings may be
severely worn. At approximately 98, a ‘Carriage Axis Error’ will result.
Push the carriage to the left end of printing area. Power the printer on,
carriage head should return to station and size the media without error.