Kenwood TK-5910 - Manual (Page 40)

34
• Send the GPS data
Press this key when the GPS unit has been installed to send your positioning data
to the base station.
• Site Lock
Press this key to lock the current site. “SITE LOCK” appears on the display and
the transceiver cannot search for alternate sites. Press and hold the Site Lock
key for seconds to unlock the transceiver to allow roaming again.
• Speaker 1 – 2 Mute
Press this key to mute the secondary speaker when using a dual-head system.
The Head speaker will mute when pressing this key from the Head unit, and
the Head speaker will mute when pressing this key from the Head unit.
• Squelch Level
Press this key to adjust the transceiver squelch level. When adjusting the squelch
level, use the the GRP and keys or the CH control to increase and
decrease the squelch level from 0 (open) to 9 (tight). The default setting is 5.
• Status
Refer to “FleetSync: ALPHANUMERIC -WAY PAGING FUNCTION” on page 9
and “M
aking a
S
tatUS
c
all
” on page 4.
• System Search
Press this key to view the current Trunking site. With the site displayed, press
the System Search key again to enter Search mode. “SEARCH” appears on the
display and the transceiver begins searching for a new site. When a site is found,
searching ends and the transceivver switches to the new site.
• Tactical Group
Press and hold this key for second to register the selected channel as a Tactical
Group channel. Press and hold this key for 3 seconds to register all channels
within the current zone as Tactical Group channels.
• Talk Around
Press this key to toggle Talk Around ON and OFF. When activated, “TA” appears
on the sub-display. Talk Around redirects the transceiver signals directly to other
party members rather than relaying the signals through a repeater.
• Talkgroup
Refer to “Making Group Calls (P5)” on page 3.
• Tone
Press this key to toggle the transceiver audible tones ON and OFF.
• Zeroize
Press and hold this key for the pre-programmed zeroize delay time, to delete the
Encryption key.
• Zone Down
Press this key to decrease the zone number {page }.
• Zone Select
Using the CH control, turn clockwise to increase the zone number and
counterclockwise to decrease the zone number {page }.
• Zone Up
Press this key to increase the zone number {page }.