Kenwood TK-5910 - Manual (Page 22)

6
p
rioriTy
S
cAn
A Priority channel must be programmed in order for Priority Scan to function.
When using a single Priority channel, the transceiver will automatically change to
the Priority channel when a call is received on it, even if a call is being received
on a normal channel.
When using dual Priority channels, Priority channel is given precedence over
Priority channel . So, if a call is received on Priority channel while a call is
already on Priority channel , the transceiver will automatically change to Priority
channel .
• “P” appears on the sub-display when the displayed channel is Priority channel , “P”
appears when the displayed channel is Priority channel , and “PP” appears when the
displayed channel is both Priority channel and Priority channel .
S
cAn
r
everT
The Scan Revert channel is the channel selected when you press the PTT switch
to transmit during Scan. Your dealer can program one of the following Scan
Revert channels:
• Selected: The last zone and channel selected are assigned as the new revert zone and
channel.
• Selected + Talkback: If the zone and channel have been changed during Scan, the
newly selected zone and channel are assigned as the new revert zone and channel.
The transceiver “talks back” on the current receive channel.
• Priority 1: If your dealer has programmed a Priority channel, this channel is the
revert zone and channel.
• Priority 1 + Talkback: If your dealer has programmed a Priority channel, this channel
is the revert zone and channel. The transceiver “talks back” on the current receive
channel.
• Priority 2: If your dealer has programmed a Priority channel, this channel is the
revert zone and channel.
• Priority 2 + Talkback: If your dealer has programmed a Priority channel, this channel
is the revert zone and channel. The transceiver “talks back” on the current receive
channel.
• Last Called: The last channel on which you made a call is assigned as the new revert
channel.