Kenwood TK-5910 - Manual (Page 25)

9
FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION
FleetSync is an Alphanumeric -way Paging Function, and is a protocol owned by
Kenwood Corporation. FleetSync enables a variety of paging functions on your
transceiver, some of which depend on dealer programming.
Note: This function is available only in Conventional FM Operation.
K
ey
F
uncTionS
Key Function
Selcall or Selcall + Status Press to change the transceiver mode as shown in
the diagram below.
CH control
Rotate to select an ID from the pre-programmed ID
list or Status list.
PTT switch or PF 4 key Press to initiate a call.
Keypad 0 ~ 9
Use the DTMF keypad to enter Selcall or Status
numbers.
PF 3 or DTMF # key
When dialing a number manually, press to delete a
character or press and hold to delete all characters.
PF or DTMF key
Press to exit Selcall or Status mode. Press and
hold to toggle between list selection and manual
entry (if enabled). In Stack mode, press to toggle
the display between ID/message, receive channel,
and time stamp, or to delete the selection.
PF key Press to exit Selcall or Status mode.
Depending on how your dealer programmed the transceiver, Selcall mode may be skipped or the
transceiver may exit Selcall mode automatically (as shown by the dash arrow).
After entering Selcall mode by pressing the Selcall + Status key, you can enter Status mode by
pressing the PF2 key.
Selcall Mode
1
Status Mode
2
Stack Mode
New Message
Display Mode
Normal Operating Mode
Press PF2
Press Selcall or Selcall Status
Receive a
new message
Press
any key
Hold Selcall, Status
or Selcall Status
Press PF1
Press
PF1