Kenwood TK-5910 - Manual (Page 17)

BASIC OPERATIONS
S
wiTching
p
ower
on/ oFF
Press the switch to switch the transceiver ON.
• A beep sounds and the display momentarily lights up.
• If the Transceiver Password function is programmed, “PASSWORD” appears on the
display. You must enter the password to unlock the transceiver. Refer to “Transceiver
Password”, below.
Press and hold the switch for approximately second to switch the transceiver
OFF.
■
Transceiver Password
To enter the password:
1 Rotate the CH control to select a digit.
2 Press the GRP
key to accept the entered digit and move to the next
digit.
3 Repeat steps and to enter the entire password.
• The password can contain a maximum of 6 digits.
• Press the
PF 3 key to delete an incorrectly entered character. Press and hold
the PF 3 key to delete all characters.
4 Press the PF 2 key to confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
To enter the password using a DTMF keypad:
1 Press the DTMF keys corresponding to the password digits.
• The password can contain a maximum of 6 digits.
• Press the
PF 3 or DTMF # key to delete an incorrectly entered character. Press
and hold the PF 3 or DTMF # key to delete all characters.
2 Press the PF 2 or DTMF key to confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
A
djuSTing The
v
olume
Rotate the VOL control clockwise to increase the volume and counterclockwise to
decrease the volume.