Kenwood TK-5910 - Manual (Page 23)

7
S
cAn
p
rogrAmming only
>
Note: Scan programming is only available when using Conventional operation.
■
Conventional Operation
If Scan Type has been programmed for Conventional operation, you are able
to reprogram your scan list.
1 Press the key programmed as Scan Program.
• The (KCH-4 ) or SCAN (KCH-5) icon appears on the display and blinks.
2 Press the GRP and keys or rotate the CH control to select the zone
and channel you will add to or remove from the Scan list.
• Press the PF 2 key to toggle between Zone Select and Channel Select.
3 Press the PF 4 key to add or remove the selected zone or channel to/ from
the scan list.
• The zone add indicator (KCH-4: / KCH-5: )/
channel add indicator (KCH-4: / KCH-5: ) will
appear on the display when the selected channel is added to the scan sequence.
4 Press the PF 1 key to exit scan programming.
If the Priority channel has been set as Operator Selectable by your dealer, you
are able to reprogram the Priority mode as well.
1 Press the key programmed as Scan Program.
• The (KCH-4) or SCAN (KCH-5) icon appears on the display and blinks.
2 Press and hold the PF 3 key to edit the Priority channel.
3 Press the GRP
and keys or rotate the CH control to select the
channel you will set or unset as Priority.
4 Press the PF 4 key to toggle the selected channel between Priority and
Normal.
• “P”, “P”, or “PP” appears on the sub-display when Priority mode is selected.
5 Press the PF 3 key again to set the new channel setting.
6 Press the PF 1 key to exit scan programming.