Kenwood TK-5910 User Manual

Page 18

elecTing

one

And

hAnnel

Select the desired zone using the

GRP

and

keys. Each zone contains a

group of channels.
Select the desired channel using the

CH control. Each channel is programmed

with settings for transmitting and receiving.

• If programmed by your dealer, the transceiver will announce the zone and channel

numbers as you change them.

Names can be programmed for zones and personalities. Your dealer can set the

zone name to a length of 0 to 4 digits. To fit on the display, personality names

will shorten appropriately. (KCH-4 models display only digits). For example,

if the channel name is “–CHANNEL–” and the zone name is “Kenwood”, and

your dealer sets the zone name to 4-digits, the following display will appear:
KCH-4 (-digit display):

KENW–CHANNEL

KCH-5 (4-digit display):

KENW–CHANNEL–

rAnSmiTTing

For Trunking channels, refer to “Making Group Calls” and “Making Individual

Calls” on the following page.
1 Select the desired zone and channel using the GRP

and

keys and the

CH control.

2 Press (or press and hold) the key programmed as Monitor to check whether

or not the channel is free.

•

If the channel is busy, wait until it becomes free.

3 Press the microphone PTT switch and speak into the microphone. Release

the

PTT switch to receive.

• The TX indicator lights red while transmitting. The BUSY indicator lights green while

receiving a signal. This indicator can be disabled by your dealer.

• For best sound quality at the receiving station, hold the microphone approximately

.5 inches (3 ~ 4 cm) from your mouth.

This manual is related to the following products: