Konica Minolta BIZHUB C203 - Manual (Page 65)

bizhub C203/C253/C353 5-5
Installation on Macintosh computers 5
Specifying the AppleTalk settings for this machine
% Enable AppleTalk in "AppleTalk Setting", and then enter the printer name.
!
Detail
For details on the AppleTalk settings of this machine, refer to the User manual – Network Administrator.
Specifying the AppleTalk settings for the computer
Specify the AppleTalk settings for the Macintosh computer connected to this machine.
1
On the "Apple" menu, select "System Preferences".
2
Click the "Network" icon.
3
From "Show", select "Built-in Ethernet".
4
Click the AppleTalk tab, and then select the "Make AppleTalk Active" check box.
5
Click the close button at the upper left corner of the dialog box.
– When the "Apply configuration changes?" message appears, click the [Apply] button.
Adding a printer (AppleTalk settings)
1
Select "HDD" - "Applications" - "Utility" where the driver was installed, and then double-click "Printer
Setup Utility" or "Print Center" to open it.
2
When the Add Printer dialog box appears, click the [Add] button. When the printer list appears, click
the [Add] button.
– If available printers have already been set up, the Add Printer dialog box does not appear.
– If the printer is not detected, turn off this machine, then on again.
– When turning off the power, then on again, wait at least 10 seconds before turning it on again.
Otherwise, this machine may not function properly.
The connected printers are detected.
3
From the "Printer Name" list, select the desired model name and connection (AppleTalk).
4
Select "KONICA MINOLTA" in "Print Using", select the desired model from the list of models, and then
click the [Add] button.
If the selected printer is registered in the printer list, the setting procedure is completed.
2
Note
If the Installable Options window appears, proceed to change the option settings as necessary. For
details, refer to "Initializing the printer driver" on page 9-4.