Kodak ESP 5200 Series - Manual (Page 13)

www.kodak.com/go/aiosupport 8
KODAK ESP 5200 Series All-in-One Printer
8. When the confirmation message appears, press OK.
9. If you haven’t yet installed the printer software, insert the CD that came with
your printer, and install the software.
Using WPS to
connect to a Wi-Fi
network If your router supports Wi-Fi Protected Setup (WPS), you can use WPS Connect.
WPS lets you configure your printer for a wireless network by pressing buttons or
entering a PIN.
To connect to a network using WPS:
1. Press Home.
2. Press to select Network Settings, then press OK.
3. With WiFi Setup Wizard selected, press OK.
NOTE: The Wi-Fi radio is turned on automatically when you select Wi-Fi Setup
Wizard.
4. Press to select WPS Connect, then press OK.
5. Select one of two methods of connecting:
IMPORTANT: Before you press
OK on the printer, make sure you know where the router's
push button is, or where to enter the generated PIN.
If necessary, consult your Internet service provider or router device
manufacturer’s documentation for more information.
• To use push buttons:
a. With Push Button Configuration selected, press OK.
b. You will have two minutes to push the WPS button on your router (this may
either be a physical button on the router or a virtual button in the router’s
software).
• To enter a PIN:
a. Press to select Generate WPS PIN, then press OK.
b. Go to your router’s software and locate the PIN button.
c. Enter the PIN you received on the LCD into the PIN screen for your router.
6. When the confirmation message appears, press OK.
7. If you haven’t yet installed the printer software, insert the CD that came with
your printer in your computer and install the software.
The printer with a wireless connection is listed as the name of the printer plus a
number (for example, KodakESP5200+1133).