Attach the power cord, Print a status page – Kyocera FS-6700 User Manual

Page 51

1-26

10. Attach the Power Cord

1. Check that the power switch is off.

2. Plug one end of the power cord into the receptacle at the back of the printer.

3. Plug the other end into the wall outlet.

11. Print a Status Page

Test that the printer works by printing out a status page as follows.

1. Switch on the printer’s power. The message display should indicate

Self test

Note

When the printer is first switched on after the toner container is installed, there will be a delay of
several minutes (approx. 10 minutes) before the printer will be ready to print. During this period,

the toner indicator will flash and the message display will show

Please wait

2. Wait until the ON LINE indicator is also lit and the message display indicates

Ready

3. Press the STATUS key. The printer should print a page listing the positions of margins, memory

allocation, and other information.

A sample status printout is shown in Chapter 2.

1.4. Setting Up and Interfacing

Power Cord

Power Cord
Receptacle