Kenwood TK-270G - Manual (Page 2)

TK-260G/270G
2
GENERAL / SYSTEM SET-UP
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced technicians
familiar with similar types of commercial grade communications
equipment. It contains all required service information for the
equipment and is current as of the publication date. Changes
which may occur after publication are covered by either Service
Bulletins or Manual Revisions. These are issued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment information,
the full part identification number should be included. This
applies to all parts, components, kits, or chassis. If the part
number is not known, include the chassis or kit number of which
it is a part, and a sufficient description of the required
component for proper identification.
PERSONNEL SAFETY
The following precautions are recommended for personnel
safety:
● DO NOT transmit until all RF connectors are verified secure
and any open connectors are properly terminated.
● SHUT OFF and DO NOT operate this equipment near
electrical blasting caps or in an explosive atmosphere.
● This equipment should be serviced by a qualified technician
only.
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and alignment
procedures contained within.
NOTE
WE CANNOT guarantee oscillator stability when using
channel element manufactured by other than KENWOOD or
its authorized agents.
Unit
X57-587X-XX X54-325X-XX
Model & Frequency range Remarks Helical Antenna Charger Battery 16 Key
destination 0-10 0-11 0-21 0-10
TK-260G
K _ – OP –
M _ –
150~174MHz
IF1 : 49.95MHz _
OP OP
–
TK-270G
K _ _ LOC : 50.4MHz OP _
M _ _ _ _
SYSTEM SET-UP
Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
Delivery
Are you using the speaker microphone?
TX/RX 150~174 5.0W TK-260G K,M TK-270G K,M
Frequency range (MHz) RF power Type
A personal computer (IBM PC or compatible), programming
interface (KPG-22), and programming software (KPG-56D)
are required for programming.
(The frequency, TX power HI/LOW, and signalling data are programmed
for the transceiver.)
YES
NO
KMC-17 or KMC-21
Speaker microphone
(Option)