Kenwood TK-270G - Manual (Page 16)

TK-260G/270G
16
DISASSEMBLY FOR REPAIR
Separating the case assembly from the chassis.
1. Remove the two knobs z and three round units x .
2. Remove the two screws c .
3. Expand the right and left sides of the bottom of the case
assembly, lift the chassis, and remove it from the case
assembly
v .
4. Taking cure not to cut the speaker lead b , open the chassis
and case assembly, and pull the speaker lead with
connector n .
Separating the chassis from the unit.
• TK-260G
1. Remove the twelve small screws m , and the three large
screws , .
2. Remove the solder from the antenna terminal using a
soldering iron, then lift the unit off (X57).
• TK-270G
1. Remove the three screws . .
Lift the unit (X54), and rise up the connecter lever in the
arrow with your finger / .
Remove the three hexagonal bosses - , and remove the
twelve screws m .
2. Remove the solder from the antenna terminal using a
soldering iron, then lift the unit off (X57).
TK-270G
TK-260G
stopper
❷
❹
❸
❶
❸
❷
❶
❷
❶
❷
CN3
b
n
TK-270G
Antenna teminal
X54-
X57-
X57-
❾
❿
➐
❽
❾
❾
❽
❽
➐
➐
➐
➐
➐➐
➐
➐
➐
➐
➐
Ω
Ω
Ω
11