Kenwood KOS-A300 User Manual
Page 7
English
|
7
Source function item
Function
Setting
Entry
Setting overview
Condition
Page
“iPod BY HAND”
“ON”/ “OFF”
When set to “ON”, allows you to operate iPod with the
control on the iPod.
14
“RELATED SRCH”
—
Starts Related search.
13
“FILE SCAN”
“ON”/ “OFF”
When set to “ON”, plays the intro of the music in the
folder successively.
—
“FOLDER RDM”
“ON”/ “OFF”
When set to “ON”, plays the music in the folder
randomly.
—
“ALL RANDOM”
“ON”/ “OFF”
When set to “ON”, all songs in iPod are played at
random.
14
“FILE REPEAT”
“ON”/ “OFF”
When set to “ON”, plays the music repeatedly.
—
“FOLDER REP”
“ON”/ “OFF”
When set to “ON”, plays the music in the folder
repeatedly.
—
“AUTO MEMORY”
—
Memorizes 6 stations with good reception
automatically.
17
“Channel Scan”
—
Every receivable Channel is checked for 10 seconds.
28
Preference item
Category
Item
Setting
Entry
Setting overview
Condition Page
“FAV”
—
Enters the Favorite Preset Recall mode.
—
15
“MENU”
“Input Level ADJ”
“-8” - “0”
AUX: “-8” - “+8”
1 sec.
Adjusts the input level.
16
“SRC Select”
“1”*/ “2”
Sets the source selection method.
4
“Skip Search”
“0.5%”*/
“1%”/ “5%”/
“10%”
Sets the ratio of skip performed with
12
“Device Regist”*
—
1 sec.
Register a Bluetooth device (pairing).
23
“SPCL DVC Select”*
—
1 sec.
Allow registration of a special device that cannot be
registered normally.
23
“Phone Selection”*
—
1 sec.
Select a cell-phone subject to hands-free connection.
25
“Audio Selection”*
—
1 sec.
Select the Bluetooth audio player to be connected.
—
25
“Device Delete”*
—
1 sec.
Cancel registration of the Bluetooth device.
25
“BT DVC Status”*
—
1 sec.
Display the status of the Bluetooth device.
—
*
“PIN Code Edit”*
—
1 sec.
Specify the PIN code required when registering this unit
using the Bluetooth device.
24
“Auto Answer”*
“OFF”/ “0S” –
“8S”* – “99S”
Answer a call automatically after lapse of the preset
time interval for automatic answer.
*
“SP Select”*
“All”*/ “Left”/
“Right”
Specify the voice output speaker.
*
“Call Beep”*
“ON”*/ “OFF”
Output a beep from the speaker when a call comes in.
*
“Beep Level”*
“1” - “5”
Setting the call beep sound volume.
—
—
“Beep Pattern”*
“1” - “4”
Setting the beep sound pattern.
—
—
“BT F/W Update”*
—
1 sec.
Display the firmware version and update the firmware.
25
“Illumi SYNC”
“OFF”/ “ON”*
Synchronizes the illumination color of the display with
that of the controller.
5
“Display”
“OFF”/ “ON”*
Turns off the display when no operation is performed.
—
*
*Factory setting
* Function of KOS-A300 with KCA-BT200.
* Refer to