Kenwood KOS-A300 - Manual (Page 6)

6 | KOS-A300
Function Control
Functions in the table below can be set up by using Function Control.
1 Enter Function Control mode
Press the [FNC] button.
2 Select a Function group
Push the Control knob towards right or left.
Pushing the Control knob towards left allows you
to set the preference items (“MENU” or “SETUP”).
Pushing the Control knob towards right allows you
to set the currently selected source function item
ON/OFF.
3 Select your desired setup item
Operation type Operation
Movement between items Turn the Control knob.
Selection of item
Press the Control knob.
Return to previous item Press the [FNC] button.
Select “Return” at the bottom of the item list.
Repeat selection and determination until your
desired setup item is selected.
Example:
In this manual, the above selection is
indicated as
Select “MENU”
> “Scroll”.
Each item’s ” & ” will be ” ✓ ” when the source function
is set to ON.
4 Make a setting
Push the Control knob towards up or down.
Press the Control knob to set the source function
item ON/OFF.
• Some items require you to keep pressing the
Control knob for 1 or 2 seconds so that you can
make a setting. For these items, the time during
which you need to keep pressing the Control
knob is displayed in the Entry column in seconds.
• A reference page number is listed along with the
function for a detailed explanation.
5 Exit Function Control mode
Press the [FNC] button.
Press the [FNC] button several times until you
return to the desired hierarchy.
Displayed controls and settings are dependent on
the currently selected source or mode. Observe
the source and mode markings in the condition
column.
: Can be set in other than standby state.
: Can be set in standby state.
: Can be set while Audio file source of iPod/ Zune/
USB device.
: Can be set while Audio file source of Zune/ USB
device (excluding iPod).
: Can be set only during playback of the iPod.
: Can be set only during playback of the Zune.
: Can be set only during playback of the Music
Editor media.
: Can be set while accessing AUX source.
: Can be set while HD Radio source.
: Can be set during Satellite radio source.
: Can be set while a cell-phone is connected.
— : Can be set during all sources.
The Control knob is used for entry, but how to use
the knob varies depending on the setting items.
: Press the Control knob to switch the settings.
: Push the Control knob towards left or right to
switch the settings.
: Turn the Control knob to switch the settings.
1 sec. : Press the Control knob for 1 second to enter into
the setting mode.
2 sec. : Press the Control knob for 2 seconds to enter into
the setting mode.
⁄
• Refer to the respective page for information on how to set
the items with reference page number.
• Only the items available to the current source are displayed.
• The connected cell-phone must have the SMS function to
use the “SMS” function.
• This unit supports KENWOOD Music Editor version 3.0 (page
29) or later. If “FILE SCAN” is selected while a media file in
KENWOOD Music Editor is playing, media files are played as
follows:
- First 10 seconds or the part picked by Intro Skip.
During Intro Skip, turn the control knob left or right to
change the song.
The scan method depends on the Music Editor setting. See
the Music Editor help for details.