Kenwood KOS-A300 - Manual (Page 37)

English | 37
3 Install Bracket (Accessory 6).
When using spacer (Accessory 5)
Accessory!
(Ø4 X 16.5)
When not using spacer (Accessory 5)
Accessory@
(Ø4 X 4.5)
You can also install it using a double-sided tape
(Accessory ~)
When using spacer (Accessory 5)
Accessory#
When not using spacer (Accessory 5)
Accessory#
⁄
• Install the controller using the screws (Accessory-/=)
when it cannot be secured firmly using the double-sided
tape.
• Thoroughly wipe away and dust or grease from the
installation location using a cloth which has been soaked
in a neutral cleaning agent and wrung out. Attach after
allowing the installation location to dry.
• Do not attach the double-sided tape more than once or
touch the adhesive with your fingers as this will weaken its
adhesive strength.
• If the temperature of the surface of the installation location
is low, warm it up using a heater or other means before
attaching the stand. Low temperature may weaken the
adhesive the double-sided tape.
4 Install the controller to bracket (Accessory 6).
Accessory6
Controller
⁄
• When you remove the controller from bracket (Accessory
6), turn the controller while pressing the release button.
Release button