Kenwood KOS-A300 - Manual (Page 31)

English | 31
Menu Glossary
• Auto Answer
This function automatically answers (responds
to) a call after lapse of the preset time interval for
automatic answer.
“OFF” : Does not answer the phone call
automatically.
“0” : Automatically answers the phone call at once.
“1s” – “99s” : Automatically answers the phone call
after lapse of 1 – 99 seconds.
⁄
• If the time set in the cell-phone is shorter than that set in
the unit, the former will be used.
• This function does not work for call waiting.
• Call Beep
You can output a beep from the speaker when a
call comes in.
“ON” : Beep is heard.
“OFF” : Beep is canceled.
• Display
If this unit is not operated at least 5 seconds with
“OFF” selected, the display turns off. During a setup
mode, the display will not turn off even if 5 seconds
lapse.
• DISP DIM
Reduces the display Illumination brightness.
AUTO: Dims the illumination in conjunction with
the Light switch of the vehicle.
MNAL1: Dims the illumination constantly.
MNAL2: Dims the illumination darker than MNA1.
OFF: Does not dim the illumination.
• DISP
N/P
Switches the display between positive or negative.
In addition, you can reverse it in conjunction with
the interior light.
POSI1 : Displays the text in the positive.
POSI2 : When the interior light is off, the text is
displayed in the positive; when the interior
light is on, the text is displayed in the
negative.
NEGA1 : Displays the text in the negative.
NEGA2 : When the interior light is off, the text
is displayed in the negative; when the
interior light is on, the text is displayed in
the positive.
• BT DVC Status
You can display the connection status, signal
strength, and battery level.
: Battery level of cell-phone.
Full Nearly dead
: Signal strength of cell-phone.
Maximum Minimum
⁄
• Icons are not displayed if information cannot be
obtained from the cell-phone.
• Since the number of steps for signal and battery level
may differ on this device compared to your phone you
could experience some inconsistancies.
• Receive Mode
Sets the receive mode of the HD Radio.
Auto: Automatically tunes to analog broadcast
when there is no digital broadcast.
Digital: Digital broadcasts only.
Analog: Analog broadcasts only.
• Seek
Mode
Select a tuning mode of the HD Radio.
Tuning mode Display Operation
Auto seek “Auto1” Automatic search for a station.
Preset station seek “Auto2” Search in order of the stations in the
Preset memory.
Manual “Manual” Normal manual tuning control.
• SP Select
You can specify the voice output speakers.
“All” : Outputs voice from the left and right speakers.
“Right” : Outputs voice from the right speaker.
“Left” : Outputs voice from the left speaker.
⁄
• Select the speaker which is further from the microphone
in order to prevent howling or echoes.
• Supreme
Technology to extrapolate and supplement with
proprietary algorithm, the high-frequency range
that is cut off when encoding at low bit rate (less
than 128Kbps, Sampling frequency is 44.1kHz).
Supplementing is optimized by compression
format (AAC, MP3, and WMA) and processed
according to bit rate.
The effect is negligible with music that is encoded
at high bit rate, variable bit rate or has minimal high
frequency range.