Kenwood KOS-A300 - Manual (Page 24)

24 | KOS-A300
Bluetooth Setup
Function of KCA-BT200 (Optional Accessory)
Downloading the Phone Book
Download the phone book data from the cell-
phone so you can access the phone book from this
unit.
To download automatically
If the cell-phone supports a phone book
synchronization function, the phone book is
downloaded automatically after Bluetooth
connection.
⁄
• Setting on the cell-phone may be required.
• If no phone book data is found in the unit even after the
“Completed” display, your cell phone may not support
automatic download of phone book data. In this case try
downloading manually.
To download from the cell-phone manually
1 By operating the cell-phone, end the hands-free
connection.
2 By operating the cell-phone, send the phone
book data to this unit
By operating the cell-phone, download the phone
book data to this unit.
• During downloading:
“Downloading” is displayed.
• After completion of downloading:
“Completed” is displayed.
3 By operating the cell-phone, start the hands-
free connection.
To clear the downloading completion message
Press any button.
⁄
• Up to 1000 phone numbers can be registered for each
registered cell-phone.
• Up to 32 digits can be registered for each phone number
along with up to 50* characters representing a name.
(* 50: Number of alphabetic alphabetical characters.
Fewer characters can be input depending on the type
of characters.)
• To cancel downloading of the phone book data, operate
the cell-phone.
Registering PIN Code
By operating the Bluetooth device, specify the PIN
code necessary for registering this unit.
1 Select PIN code edit mode
Select “MENU” > “PIN Code Edit”.
For how to select Function Control item, refer to
(page 6).
2 Enter PIN code edit mode
Press the Control knob for at least 1 second.
The current setting of PIN code is displayed.
3 Input the PIN code
Operation type Operation
Select the numbers. Turn the Control knob or push it towards
up or down.
Move to the next digit. Push the Control knob towards right.
Delete the last digit. Push the Control knob towards left.
4 Register a PIN code
Press the Control knob for at least 1 second.
If “Completed” is displayed, registration is
completed.
5 Exit PIN code edit mode
Press the [FNC] button.
⁄
• By default, “0000” is specified.
• A PIN code can be specified with up to eight digits.