Kenwood HM-333 - Manual (Page 50)

50
Knowledge sections
Important Items
÷ Place the disc properly, with the label side facing upward.
÷ Clean the disc referring to "Disc handling precautions". i
÷ Refer to "Caution on condensation" and remove the condensation
by evaporation.
u
÷ Press the CD 6 key.
÷ Clean the disc referring to "Disc handling precautions". i
÷ Clean the disc referring to "Disc handling precautions". i
÷ Install the unit in a place not subject to vibrations.
Remedy
CD player section
A CD is placed in the player but it cannot be
played.
Sound is not produced.
Sound skips.
Symptom
Cassette deck section
÷ Clean the head referring to "Maintenance". u
÷ The tape is wound too tight due to irregular winding.
÷ Play a recorded tape.
÷ Press operation keys in more than a few seconds after closing
the cassette holder.
)
÷ Change the tape transport direction or reverse the tape insertion
orientation. )
÷ Press in stop mode.
÷ Reset the microcomputer. o
÷ Clean the head referring to "Maintenance". u
÷ Try another tape.
÷ The recording level is not set properly (when the AUX input is
recorded).
Adjust the AUX input level.
°
÷ Demagnetize the head referring to "Maintenance". u
÷ Install the system at a distance from other electric appliances and TV.
÷ Set the TAPE EQ. to on. ¡
÷ Clean the head referring to "Maintenance". u
÷ Wind the tape again by fast forwarding, rewinding or playing from
an end to the other. )¡
÷ Use a cassette with an unbroken recording protect tab or block
the hole.
i
÷ Close the holder completely. )
÷ Set the input selector to the source to be recorded. ª
÷ Change the tape transport direction or reverse the tape insertion
orientation.
)
Remedy Symptom
Sound cannot be produced by pressing the play
key.
No operation occurs even when an operation
key is pressed.
The cassette holder cannot be opened by
pressing "
0 push open".
Sound is harsh or high frequencies are not re-
produced.
Sound is distorted.
Noise is noticeable.
Sound vibrates.
Recording cannot be started by pressing the
record key.
÷ Replace with new batteries. #
÷ Operate the unit inside the remote controllable range. #
Symptom
Remote control operation is not possible.
Remedy
Remote control unit
In case of difficulty