beautypg.com

Selection of tape equalizer (tape eq.), Selection of reverse mode to stop playback, A tip for use of the tape counter – Kenwood HM-333 User Manual

Page 21: Tape counter display

background image

21

Basic section

Playback of tape

To wind tape at high speed

÷ Press the STOP 7 key to stop fast winding.
÷ The same operation is also available with the 4

and

¢ keys on the main unit.

To fast wind in
direction

\

To fast wind in
direction

|

Selection of TAPE equalizer (TAPE EQ.)

When playing a tape prerecorded with Noise Re-

duction system (such as the DOLBY NR) ON, be

sure to set the "TAPE EQ." ON for playback.

Each press switches the modes as follows.

1 "TAPE EQ." ON

(

TAPE equalizer is used)

2 "TAPE EQ." OFF

(

TAPE equalizer is not used

)

Lit when "TAPE EQ." is ON

÷ Select the "TAPE EQ." ON mode according to the re-

cording condition of the tape.

Selection of reverse mode

To stop playback

The tape counter is set to "0000" when a cas-
sette tape is loaded. By writing down the
counter reading in case you want to interrupt
recording (playback) in the middle of the tape,
the memo will be helpful as a reference for lo-
cating the same position when continuing the
recording (playback) the next time. The tape
counter figure decrements during recording or
playback of the back side (while the

2 tape

transport indicator is lit). To set the tape counter
to "0000", open the cassette holder once. Then
the counter will be reset.

A tip for use of the tape counter

1 Select "TAPE RVS. ?".

2 Select.

3 Set it.

1 " " : (ONE-WAY)

Only one side is played back (recorded), and then

the tape stops.

2 " " : (REVERSE)

Both sides are played back (recorded), and then
the tape stops.

3 "

" : (ENDLESS)

Both sides are played back endlessly. (The tape
stops after recording onto both sides.)

(The initial setting is "

"(REVERSE))

Tape counter display

1 Clock display

2 Tape counter

The displayed information is switched every time the TIME DISPLAY key is pressed.

TAPE EQ.

STOP

7

AUTO/MONO

set / demo

(Press the set/demo key while the "?" mark is
blinking)

Main unit only

Remote control unit only

menu

set / demo

volume / multi control

\

\

\

\

1

1

TUNING

TIME DISPLAY

÷

PTY

÷

TIME DISPLAY

or

(For other countries)

(For U.K. and Europe)