Kenwood HM-333 - Manual (Page 29)

29
Recording on TAPE
Basic section
5. Start recording.
4. Select the source to be recorded.
Select an input source other
than "TAPE"
÷ If a CD has already been loaded, it starts to
play now. Press the 7 STOP key to stop it.
1
Press the TAPE rec key.
2
Play (or tune) the input source to be recorded.
÷ Recording stops automatically when the tape side (s) to be recorded have
been fully recorded.
CD
TUNER (Broadcasts)
AUX (External input) [Adjusting the AUX input level °]
Pause the recording
÷ Press the TAPE rec key during recording. It stops
after leaving a non-recorded blank of 4 seconds.
(Press the key again to resume recording.)
Lights
The character information
display shows the recording
input source.
Stop the recording
Select the reverse mode. ¡
3. Set the recording condition.
÷ Check the tape transport direction before starting recording. If it is set to
the reverse direction, only one side of tape can be recorded regardless of
the reverse mode setting made here.
÷ The tape equalizer is defeated during recording.
3 3
TAPE rec
7
stop
Tuning
Mode
C D
6
CD
4 4
TAPE rec
5 5
menu
volume / multi control
set / demo
\ \
\ \
Example:
To select the CD input