Kenwood HM-333 - Manual (Page 31)

31
Application section
Various CD playback features
Let the "PGM" indicator light.
Select track numbers in the order you want to play them.
Start playback.
Select the CD input.
÷ Up to 32 tracks can be programmed. When "PGM FULL"
is displayed, no more tracks can be programmed.
÷ If you made a mistake, press the CLEAR key and enter
the track No. again.
÷ When a track No. is entered, the track will be added to
the end of the existing program.
÷ When the total time of CD program is 256 minutes or
more, the time display shows "- - : - -".
1
Select the track.
2
Confirm the selection.
Lights
Selection of tracks
(Go to step
2
within 20 seconds.)
Press the numeric keys as shown below....
To select track No. 23 : +10
X
2, 3
To select track No. 40 : +10 X 4, 0
Various CD playback features
Use the following procedure to program desired tracks in a desired order. (up to 32 tracks)
1
2
3
P G M C D
P G M C D
Program position of the track
to be selected next.
(To select more than one track, repeat steps
1 and
2 for each track.)
÷ Tracks will be played in the order they were pro-
grammed (following the program numbers).
÷ When the 4/ ¢ key is pressed during play, the pro-
gram will jump to the preceding or the following track
respectively.
÷ When the 4 key is pressed once during playback, the
play position returns to the beginning of the current
track being played.
PGM
5
2
8
0
6
3
9
4
1
7
10
SET
6
CD
Press in stop mode
Listening to the desired sequence
(program playback)