Kenwood HM-333 - Manual (Page 20)

20
Playback of tape
Basic section
1. Load a cassette tape.
1 Press the area marked 0 push open to open the cassette
holder.
2 Insert a tape.
3 Press the area marked 0 push open to close the cassette
holder.
2. Start playback.
Press the TAPE
2 3 key of the desired direction.
To stop playback
Selection of TAPE equalizer (TAPE EQ.)
Selection of reverse
mode
To wind tape
at high speed
Start playback
To stop playback
To wind tape at high speed
1 1
Playback of tape
÷ The tape deck of the unit can play Normal (Type ), High (Type ) and
Metal (Type ) tapes.
÷ Remove tape slack before loading.
If you load a tape in the cassette deck in advance while the power is off. Pressing the TAPE
2 3 key turns
power on automatically and starts the tape playback.
T A P E P L A Y
Displayed when the deck
is loaded with a tape. Reverse mode indication
Transport direction indicators
Tape counter
Do not use a cassette with more than 90-minute recording time, for the
tape used with such a cassette is very thin and tends to cause troubles
such as entanglement around the pinch roller or cutting of tape.
1 1
0
push open
2 2
Transport direction indicators:
Indicates the tape transport direction during playback or recording by lighting
of
2 or 3. This direction is the direction stored in memory when the tape was
last stopped.
TAPE
2 3
2 2
Start playback
Selection of TAPE equalizer (TAPE EQ.)