Kenwood HM-333 - Manual (Page 40)

40
Timer operation
Application section
A D J U S T
Enter the figure of hour.
1
Enter the figure of hour.
2
Set it.
As the clock is not used to show the time of the day but is also used in timer operations, be sure to set the
clock in advance.
2
Clock adjustment
To decrease
hour
To increase
hour
Example: Adjustment to 8:07
Activate the clock adjustment mode.
1
Press and hold for more than 2 sec. when the
power is ON.
÷ The time display starts to blink.
÷ In other areas than the U.K. and Europe the clock
shows the time of the day in the 12-hour system.
÷ Press the set/demo key. The hour is entered and the
minute display starts to blink.
Enter the figure of minute.
1
Enter the figure of minute.
2
Set it.
3
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the
set/demo key, the display shows "COMPLETE !".
÷ After a power failure or the power cord has been un-
plugged then plugged in again, it is required to set the
time again.
÷ When the 7 STOP key is pressed while the power is in
the standby mode, the time of the day will be displayed
for 5 seconds.
Example: Adjustment to 8:07
menu
volume / multi control
set / demo
To decrease
minute
To increase
minute
volume / multi control
set / demo
A D J U S T
A D J U S T