KORG TRITON Le Electric Keyboard - Manual (Page 61)

54
Even when this dialog box is not opened, you can set
this value to the current location by holding down the
[ENTER] key and pressing the [LOCATE] key.
GM Initialize
This command transmits a GM System On message to
Sequencer mode, resetting all tracks to the GM settings
(refer to the table below).
In Sequencer mode when a GM System On message is
received from an external device or the tone generator
will be reset to the GM settings in the same way as
when this command is executed (However even in
these cases, the parameters of the 7.2: Master Fx will not
be reset).
1.1–2: Prog...8 (Program T01...08)
1.1–3: Prog...16 (Program T09...16)
Here you can make basic settings such as selecting the pro-
gram used by each track.
1.1–2(3)a: Program
Program Select
[A...D/000...127, G001...128, g001...g128:d]
Here you can select the program that will be used by each
track.
When this parameter is selected, you can use the VALUE
controller to make a selection. At this time, the BANK
SELECT key LEDs will light to indicate the bank of the
selected program.
The track number and the abbreviated category name of the
selected program are displayed above “Program Select.”
By holding down the [TIMBRE/TRACK] key and
pressing a [F1](T1/T9)–[F8](T8/T16) key you can move
to the corresponding track “T1”–“T16.”
The program bank can also be selected directly by using
the BANK [A]–[GM] keys.
When this parameter is selected, you can use the Utility
menu command “Select by Category” to select a pro-
gram by category. (☞p.2)
GM Initialize Parameters
1.1–2a
1.1–1c
1.1–2b
1.1–2c
Parameter Track1–9, 11–16 Track10
1.1 Program Select G001:Acoustic Piano g001: (d): STANDARD Kit
Pan C064 C064
Volume 100 100
3.1 Status – – The setting remains unchanged
3.2 Use Program’s Scale – – The setting remains unchanged
6.1 Arpeggiator Assign – – The setting remains unchanged
Other Arpeggiator parameters – – The setting remains unchanged
7.1 IFX/Indiv.Out BUS Select L/R DKit
Send1(MFX1) 0 0
Send2(MFX2) 40 40
IFX – – The setting remains unchanged
Pan(CC#8) – – The setting remains unchanged
BUS Select – – The setting remains unchanged
Send1 – – The setting remains unchanged
Send2 – – The setting remains unchanged
Other Insert Effect parameters – – The setting remains unchanged
7.2 MFX1 – – 16: St. Chorus
MFX2 – – 53: Rev Smth. Hall
Return1 – – 127
Return2 – – 050
Other Master Effect and Master EQ parameters – – Default settings