Canceling wireless/ remote flash mode – Konica Minolta MAXXUM 3 User Manual
Page 53

3. Press the subject program button
to test fire the wireless/ remote
flash.
• If the accessory flash does not fire, change
its position.
4. When both flash units are fully charged, press the shutter-
release button all the way down to take the picture.
• If the exposure from the accessory flash was sufficient for the subject, the
flash signal on the flash unit will glow.
2. Wait until both flash units are fully
charged.
• When the shutter-release button is pressed
partway down, the viewfinder flash signal
will show the status of the built-in flash.
• When the accessory flash is charged, the
AF illuminator on the front blinks, and the
flash signal on the rear of the unit glows.
Canceling Wireless/ Remote Flash Mode
1. Attach the accessory flash to the
camera.
2. Press the flash mode button on the
camera until WL no longer appears
in the data panel.
• Turning off the camera with the accessory
flash attached also cancels wireless flash.
If the flash is not attached, the
wireless/remote function will not be
canceled on the flash unit. Refer to the
flash’s instruction manual to cancel the function.
53
2165_E.qxd 03.2.10 2:06 PM Page 53