Konica Minolta MAXXUM 3 - Manual (Page 20)

20
ATTACHING THE STRAP
GETTING STARTED
4. Pass the tip of the strap through the
holder ring.
• If the ring is tight, fold the strap, and slide the
holder ring over the tip (1). Hold the strap, and
slide the holder ring in the direction shown (2).
2. With the visible protrusions on the
inside of the holder ring oriented as
shown, pass the tip of the strap
through the ring.
3. Pass the tip of the strap through the
camera’s strap eyelet from below.
• Attach the strap so the tip comes between the
strap and the camera.
• The eyepiece cap should be on the same side of
the camera as the flash mode button.
1) 2)
Holder ring
Protrusions
1. Confirm the eyepiece cap is attached
to the strap. The strap is threaded
through the cap to prevent loss.
Eyepiece cap
2165_E.qxd 03.2.10 2:06 PM Page 20