Kenwood KRF-X9090D - Manual (Page 19)

19 EN
Preparing for surround sound
Before setting up the speakers
For the optimum surround playback, variety of speaker settings are
necessary.
Following the procedure below, go through the settings described in
further pages.
1
When performing "Setting up the speakers automatically
(AUTO SETUP)", connect the provided microphone for setup
to the SETUP MIC jack.
2
Turn on the power to this receiver by pressing the POWER
ON/OFF key and (POWER ON/STANDBY) key, or RECEIVER
ON key.
3
If you want to use the remote control unit, press the RCV
MODE key on the remote control unit to set it to the receiver
control mode.
4
Press the SETUP key to enter the SETUP mode.
Use the 5/∞ keys or MULTI @ / # keys for the following dis-
plays.
1 AUTO SETUP
2 MANUAL SETUP
3 SW RE-MIX
4 CROSSOVER
5 SB SPACING
6 BASS PEAK
7 LFE LEVEL
8 AUDIO DELAY
9 DISPLAY MODE
0 SETTING LOCK
- EXIT
The flow of the SETUP is as follows:
AUTO SETUP
SW RE-MIX
CROSSOVER
BASS PEAK
AUDIO DELAY
DISPLAY MODE
SETTING LOCK
CALIBRATE
CONFIRM
TEST SIG LVL
RETURN
RETURN
SP SETUP
SP LEVEL
SP DISTANCE
START
Measuring
COMPLETE
RETURN
ERROR
MESSAGE
WARNING
MESSAGE
T. TONE
AUTO
T. TONE
MANUAL
T. TONE
OFF
RETURN
SB SPACING
LFE LEVEL
EXIT
Analyzing
MANUAL SETUP
05.7.16, 10:33 AM 19