Kenwood XD-500 - Manual (Page 54)

XD-750/700/550/500 (En)
5 4
Preparation section
Basic section
Application section
Knowledge sections
Ensure that the power is OFF.
Note Note
Timer operation
Adjust the clock before setting the timer.
The reservation contents cannot be cleared. The contents are
cleared only when they are changed.
Press so that all PROG. indicators are
OFF.
Press so that the desired PROG. indica-
tors lights.
Each press of the key switches the program numbers as follows.
PROG.1 ........ Program 1 operates.
PROG.2 ........ Program 2 operates.
PROG.1, 2 .... Programs 1 and 2 operate.
Not lit .......... No program operates.
÷
The reservation contents are held in memory.
Each press of the key switches the program numbers as follows.
PROG.1 ........ Program 1 operates.
PROG.2 ........ Program 2 operates.
PROG.1, 2 .... Programs 1 and 2 operate.
Not lit .......... No program operates.
÷ Also prepare the disc or tape and adjust the listening volume.
SOURCE DIRECT
(XD-550/500)
SRS 3D
(XD-750/700)
SOURCE DIRECT
(XD-550/500)
SRS 3D
(XD-750/700)
Each press of the key switches the program numbers as follows.
PROG.1 ........ Display of program 1
PROG.2 ........ Display of program 2
Normal mode
Select the program number to be
checked.
÷
The reserved contents will be displayed for 3 seconds per item. After
this, the previous display content appears again.
To change the reserved contents
Restart the procedure of “Timer programming” from the
beginning.
EX.BASS
Check the reservation content.
When timer operation is not required
To set the same timer program again