Copying tape, Tape dubbing) – Kenwood XD-500 User Manual
Page 29
XD-750/700/550/500 (En)
2 9
Preparation section
Basic section
Application section
Knowledge sections
Copying tape
(Tape dubbing)
The contents of the tape in deck A can be copied onto the
tape in deck B.
The DOLBY NR key is not active in dubbing mode. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on
deck A.
Note
Note
÷
The deck B will stop after creating a non-recorded portion of about
4 sec, and then the deck A will stop.
÷
Dubbing can also be stopped by pressing the stop (
7) key. Note that
the non-recorded space is not created in this case.
To stop dubbing
1Select the “TAPE” input.
Let's record
INPUT
2Load tapes in the decks.
3Select “[” (double-side recording)
or “
“” (one-side recording).
REV. MODE
(1) Select the deck to change the
transport direction.
(2) Press the play key corresponding
to the desired direction.
(3) Stop playback.
4Use the same tape transport direc-
tions.
7
DUBBING
5Start dubbing.
Press during stop.
A
A
Playing tape
Recording tape
ECHO
T A P E
) ) ) )
EX
.
BASS
EQ.
CLASSIC
MANUAL
POP
ROCK
VOL.
REV.MODE
B
RUNNING
INDICATOR
Running direction
÷
When recording is started, the tape will be transported in the direction
selected in this step.
ECHO
T A P E
) ) 1 2
EX
.
BASS
EQ.
CLASSIC
MANUAL
POP
ROCK
VOL.
REV.MODE
B
RUNNING
INDICATOR
DUBBING
DUBBING
A/B
Check the tape transport direction indicators.
÷
Dubbing ends automatically when the side(s) to be dubbed has been
completed.
3
¡
7
2
1